Qilive Q.6922 Manual De Instrucciones página 23

The installation will comply with all clearance requirements and applicable standards and
•
regulations.
A suitable isolating switch providing full disconnection from the mains power supply is
•
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap contact separation
•
in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of
the requirements).
The isolating switch will be easily accessible to the customer with the hob installed.
•
You consult local building authorities and by-laws if in doubt regarding installation.
•
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces
•
surrounding the hob.
10.3. AFTER INSTALLING THE HOB, MAKE SURE THAT
The power supply cable is not accessible through cupboard doors or drawers.
•
There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
•
If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed
•
below the base of the hob.
The isolating switch is easily accessible by the customer.
•
10.4. BEFORE LOCATING THE FIXING BRACKETS
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force onto
the controls protruding from the hob.
10.5. ADJUSTING THE BRACKET POSITION
Fix the hob on the work surface by screw 4 brackets on the bottom of hob (see picture) after
installation. Adjust the bracket position to suit for different table top thickness.
HOB
BRACKET
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after
installation (see picture).
Bracket
TABLE
23
HOB
BRACKET
EN
TABLE