Qilive Q.6922 Manual De Instrucciones página 21

Failure
Heating zones of
the same side (Such
as the first and the
second zone) would
display "u".
Fan motor sounds
abnormal.
The above are the judgment and inspection of common failures. Please do not disassemble the unit
by yourself to avoid any dangers and damages to the induction hob.
10. INSTALLATION
10.1. SELECTION OF INSTALLATION EQUIPMENT
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the
hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and
insulated work surface material (Wood and similar fibrous or hygroscopic material shall not be used
as work surface material unless impregnated) to avoid the electrical shock and larger deformation
caused by the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop
should be at least 3mm.
L(mm) W(mm)
590 520
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air inlet
and outlet are not blocked. Ensure the induction cooker hob is in good work state. As shown below
Problem
The power board and the
display board connected
failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
H(mm) D(mm)
62 58
21
Solution A
Check the connection.
Replace the display
board.
Replace the power
board.
Replace the fan.
A(mm) B(mm)
560+4 490+4
+1 +1
Solution B
SEAL
≥ 3mm
X(mm) F(mm)
50 min. 3 min.
EN