Idiomas disponibles
Idiomas disponibles
Ontherearoftheappliance:
-
Power c ordwithplug.
C =coldwaterconnection
H- hotwater c onnection
Usefultools
Thefollowing t oolsarehelpful:
-
Flathead screwdriver.
-
Closed wrench (1/2"/13mm).
-
Bubble level.
Dimensions
a
a - 27.0 inches (686 mm)
b - 30.7 inches (780 mm)
c -- 37.0 inches (940 mm)
d -- 16.0 inches (407 mm)
Door opening angle 180°
Approx. weight = 220 Ibs (100 kg)
Installation
area
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance
must be installed on
a solid floor and well leveled due to
the higher spin speeds available. If
installing the machine on a wood
floor over a basement
or on a
second floor, the floor may need to
be reinforced.
Sound, vibration,
and
risk of "walking"
will be affected
depending
on the structure and
stability of the floor surface where it
is installed.
If the washing machine is to be installed
on a weak wood floor consider the
following:
Soft floor surfaces, such as
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
Screw a water resistant wooden
board (at least 3/4" thick) to the
floor.
Secure the feet of the washing
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).
Units are not designed to be
stacked.
Units are not designed for under
counter installation
Pedestal
Mounting
If mounting the washer on the Bosch
pedestal (accessory no. WTZ1295) fol-
low the instructions supplied with the
pedestal.
[_
Install pedestal prior to removing
transport bolts.
Closet
If installing the washer in a closet,
observe the minimum distances
according to the following table:
Minimum Installation Clearances
Closet
Sides
1/4" (6 mm)
Top
12" (305 mm)
Rear
2.5" (64 mm)
Front
1/4" (6 mm)
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom: 24 sq. in (155 sq. cm)
Removing
the transport
bolts
To avoid possible damage to the
appliance and adjacent surfaces, all
4 transport bolts must be removed
before using the appliance for the
first time and must be retained for
any future transport (e.g. when
moving).
Release screws using the 1/2"
wrench provided until they can be
moved freely.
Completely remove all 4 transport
bolts (bolt, spring, washer and bush-
ings) by reaching through the open
washing machine door and pulling
the drum slightly forward to loosen,
then pull out from the back.
If the bushings do not come out
when removing the screws, place
screws back into the bushings and
carefully try again. It is important to
do this with the screws, otherwise
the bushings will not come out prop-
erly.
completely.
Insert the covers until they snap in
6
