Idiomas disponibles
Idiomas disponibles
PARAMETER VALUE
EnSA
no
Si
AUto
dir
L.AdJ
50 - 150
t.ASE
0.0" - 5.0"
t.rSE
0.0" - 5.0"
- 66 - ENGLISH
DESCRIPTION
Energy saving function
This function is useful for reducing the energy consumption of the
automation device while in stand-by mode.
If the function is enabled, the control unit will enter ENERGY
SAVING mode under the following conditions:
• 30 seconds after completion of an operational cycle
• 30 seconds after an opening (if automatic closure is not enabled)
• 30 seconds after exiting the programming menu
In ENERGY SAVING mode, power to the accessories, display,
flashing lights and closure electromagnets is deactivated.
ENERGY SAVING mode is exited:
• If an operational cycle is activated
• If one of the menus is accessed
Function deactivated
Function activated
The energy saving mode is automatically enabled only if the power
supply mains is down, i.e. In the event of a blackout with battery
backup
Direction
Set up the functioning directions.
This parameter must be set up based on the RIGHT or LEFT
installation of the barrier (chapter 3.6)
Installation on the right (DX)
Installation on the left (SX)
Fine adjustment of the stroke
This menu allows you to change the duration of the opening and
closing maneuver if it is not correct with respect to the adjustment
of the limit switches.
If the rod hits the limit switches and
set a lower value.
If the auction does not close completely, set a higher value.
Holding magnet anticipation time
This menu allows regulating the anticipated time with which the
holding magnet is unblocked before the barrier comes set in
opening action.
m
ATTENTION: if the holding magnet is not present, set
this parameter to zero.
NOTE: The locking electromagnet is connected to the accessory
power supply. Hence, it is essential to deactivate the energy saving
function to use it.
Holding magnet delay time
This menu allows regulating the delay with which the holding
magnet jams after the barrier has finished closing.
m
ATTENTION: if the holding magnet is not present to set
up this parameter to zero.
NOTE: The locking electromagnet is connected to the accessory
power supply. Hence, it is essential to deactivate the energy saving
function to use it
SEnS
appears on the display,
DEFAULT
DEFAULT
MEMO
NUUR4
NUUR6
no
no
100
100
0.0"
0.0"
0.0"
0.0"
