V2 NUUR4 Manual De Instrucciones página 65

8 - ACCESSING THE CONTROL UNIT
SETTINGS
1. Press and hold the OK key until the display shows the menu
desired
2. Release the OK key: the display will show the first item in the
sub-menu
-PrG
Programming the control unit (chapter 13)
-Cnt
Cycle counter (chapter 12)
-tM
Clock and timer programming (chapter 16)
Programming of the SYNCLUX accessory device
-dEF
Loading the default parameters (chapter 9)
m
WARNING: in case no operation is carried out for more
than one minute, the control unit exits from the programming
mode without saving any of your setups and changes, which
will get lost.
-PrG
2''
-Cnt
4''
-tM
6''
-E
8''
-dEF
10''
- - - -
12''
9 - LOADING THE DEFAULT
PARAMETERS
If necessary, it is possible to restore all parameters to their standard
or default values (see the final summary table).
m
customised parameters.
1. Press and hold the OK key until the display shows
2. Release the OK key: the display shows
3. Press the
4. Press the OK key: the display shows
5. Press the
6. Press the OK key: all parameters are overwritten with their default
En.SA
tot
ESC
ESC
ESC
PLEASE NOTE: This procedure results in the loss of all
key if it is desired to exit this menu)
i
key: the display shows
i
key: the display shows
values (see Chapter 13), the control units exits programming
mode and the display shows the control panel.
-dEF
no
Si
-dEF
ESC
(only press the OK
dEF
no
Si
ESC
dEF.
ENGLISH - 63 -