Changing The Vacuum Pump Oil - Dometic GROUP WAECO AirConServiceCenter ASC5000 Instrucciones De Uso

Service tasks
NOTE
I
You can look up the current atmospheric pressure for your region on the In-
ternet, for example at http://www.meteo24.de/wetter/ under "air pressure".
9. When calibration has been completed, press ENTER to exit the menu.
10. Press STOP twice to access the standby menu.
11. Screw the service couplings (14) and (15) hand-tight onto the service
hoses (12) and (13), taking care not to mix up the red and blue mark-
ings on the couplings and hoses.
9.6

Changing the vacuum pump oil

WARNING!
!
Switch off the AirCon Service Center and unplug it from the power supply
before opening the housing.
1. Before changing the oil, let the vacuum pump run for about 10 minutes
(manually, via the menu).
The following steps may only be performed by qualified personnel.
2. Take off the front panel:
Undo the screws (D) on the control panel and lift it up. Then undo the
screws (E) on the bottom of the front panel and take it off.
112
D
E
AirConServiceCenter
D
E
EN