Idiomas disponibles
Idiomas disponibles
EN
FR
DE
ES
WARNING:
petroleum based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which
may result in serious personal injury. Only the
parts shown on the parts list are intended to
be repaired or replaced by the customer. All
other parts should be replaced at an authorized
service centre.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary,
this must be done by an authorized service centre in
order to avoid a safety hazard.
NOZZLE MAINTENANCE (See Figure 8.)
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or
dirty nozzle.
Unplug the pressure washer.
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
Remove the nozzle from the lance.
NOTE: Never point the spray lance at your face.
Using a straightened paper clip or nozzle cleaning
tool, free any foreign materials clogging or restricting
the nozzle.
Reconnect the nozzle to the lance.
Turn on the water supply.
STORING THE PRESSURE WASHER
Store in a dry, covered, frost-free area where the weather
can't damage it. Always empty water from gun, hose and
pump.
NOTE: The use of a pump protector is recommended to
prevent cold weather damage during storage over the
winter months.
IT
PT
NL
SV DA NO
ENGLISH(Original Instructions)
FI
HU CS RU RO PL
8
21
SL
HR ET
LT
LV SK BG
