Idiomas disponibles
Idiomas disponibles
EN
FR
DE
ES
Pull back and hold the trigger to operate the pressure
washer.
the nozzle.
To engage the lock out:
Push down on the lock out until it clicks into the slot.
To disengage the lock out:
For the most effective cleaning, the spray nozzle should
be between 20 cm and 60 cm from the surface to be
cleaned. If the spray is too close it can damage the
cleaning surface.
USING THE NOZZLES
Before starting any cleaning job, determine the best
cleaning. The Low Pressure (black) nozzle is used to
apply detergent, or to rinse after cleaning.
CAUTION:
NEVER change nozzles without engaging the
lock out on the gun and NEVER point the lance
at your face or at others. The Quick Connect
collar contains small springs that could eject he
nozzle with some force. Failure to heed this may
cause personal injury.
Using the Quick Connect collar, changing nozzles is
easy.
To connect a nozzle to the lance:
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
Engage the lock out on the gun by pulling down on the
lock out until it clicks into the slot.
Pull back the quick-connect collar.
Push the nozzle into place in the spray wand.
Push the collar forward so that the nozzle is secured
properly.Check to see that the nozzle is secure.
To disconnect a nozzle from the lance once the
cleaning job is complete:
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
Engage the lock out on the gun by pushing down on
the lock out until it clicks into the slot.
Remove the nozzle by placing hand over nozzle then
pulling back the Quick Connect collar. Place nozzle in
the nozzle storage area.
IT
PT
NL
SV DA NO
ENGLISH(Original Instructions)
FI
HU CS RU RO PL
OPERATING THE PRESSURE WASHER
See Figure 7.
To apply soap:
Pour detergent in the detergent tank.
Install the Low Pressure nozzle on the spray lance.
Start the pressure washer and spray the detergent on
a dry surface using long, even, overlapping strokes.
To prevent streaking, do not allow detergent to dry on
the surface.
To clean:
surface for approximately 10 seconds to allow any
Start at the top of the cleaning area and work down,
overlapping the strokes.
MAINTENANCE
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING:
Before inspecting, cleaning, or servicing the
machine, shut off motor, wait for all moving parts
to stop, and disconnect plug from power source.
Failure to follow these instructions can result in
serious personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
20
SL
HR ET
LT
LV SK BG
7
