Idiomas disponibles
Idiomas disponibles
EN
FR
DE
ES
The water supply must come from a water main. NEVER
use hot water or water from ponds, lakes, etc. For ease
of use, a self-coiling hose is provided.
NOTE: When using the self-coiling hose, be sure that the
hose does not become crimped during use as this may
cause damage to the pump.
CAUTION:
When connecting the appliance to the water
supply mains (not public drinking water supply
mains), please observe the local regulations of
local boards or local water supplier.
To e n s u r e t h a t t h e r e i s n o f e e d b a c k o f
contaminant into the water supply, the appliance
must not be connected directly to the public
drinking water supply mains.
If the appliance is connected to potable water
mains, backflow prevention devices should
system. The installation should be accepted by
local boards or water supplier and should be
conducted by professional technical personnel.
The backflow prevention devices should be
appropriate to fluid categories and comply
with the requirement to avoid back siphonage
according to EN 60335-2-79:2009
Before connecting the garden hose to the pressure
washer:
Run water through the hose for 120 seconds to clean
any debris from the hose.
If the filter is dirty, clean it before connecting the
garden hose to the machine.
Attach the self-coiling hose to the water intake coupler.
Screw the threaded tap connector into the self-coiling
hose.
Straighten the garden hose.
NOTE: There must be a minimum of 3 metres of
unrestricted hose between the pressure washer intake
and the garden tap.
With the garden tap turned completely off, attach the
end of the garden hose to the threaded tap connector.
OPERATION
Applications
This pressure washer can be used for the purposes listed
below:
Removing dirt and mould from decks, cement patios,
and walls
Cleaning cars, boats, motorcycles, outdoor furniture
and barbeques
IT
PT
NL
SV DA NO
ENGLISH(Original Instructions)
FI
HU CS RU RO PL
ADDING DETERGENT TO THE PRESSURE WASHER
See Figure 6.
Use only detergents designed for pressure washers;
household detergents, acids, alkalines, bleaches,
can damage the pump. Many detergents may require
mixing prior to use.
Prepare cleaning solution as instructed on the solution
bottle.
NOTE: Use a funnel, if needed, to prevent accidental
spilling of the detergent outside the tank. If any detergent
cleaned and dried before proceeding.
S TA R T I N G A N D S T O P P I N G T H E P R E S S U R E
WASHER
CAUTION:
Do not run the pump without the water supply
connected and turned on.
Connect the garden hose.
Turn the garden hose on then squeeze the high
pressure trigger to relieve air pressure. Once a steady
stream of water appears, release he trigger.
After ensuring the switch is in the OFF position,
connect the pressure washer to the power supply.
Press ON ( I ) on the switch to start the motor.
To stop the motor, release the trigger and press OFF
( O ) on the switch.
USING THE GUN
For greater control and safety, keep both hands on the
gun at all times.
19
SL
HR ET
LT
LV SK BG
6
