Suzuki DF40A Manual Del Propietário página 44

V WARNING
Unauthorized use of your boat could lead to
an accident or damage to your boat.
To prevent unauthorized use of your boat, be
sure to remove the key and emergency stop
switch lock plate when the boat is unattended.
4. After stopping the engine, disconnect the
fuel line from the outboard motor if there is a
fuel connector.
V WARNING
If you leave the motor stopped for a long
period of time with the fuel line connected,
fuel can leak out.
Disconnect the fuel line from fuel tank, if there
is a fuel connector, whenever you leave the
motor stopped for a long period of time.
5. Turn the air-vent screw on the fuel tank cap
clockwise to shut the vent (if equipped).
NOTE:
To make sure that the emergency stop switch
operates properly, stop the engine occasionally
by pulling out the lock plate, while operating the
engine at idling speed.
MOORING
The motor should be tilted up out of the water
when you moor the boat in shallow water or if
the motor will not be used for some time, to pro-
tect it from damage by underwater obstacles at
low tide or corrosion from salt water.
Refer to the TILT LOCK LEVER section for
details on how to tilt up the motor.
NOTICE
Improperly securing your boat may cause
damage to your boat or motor, or other prop-
erty damage.
Do not allow your motor to rub against quay
walls, piers or other boats when the boat is
tied up.
OPERATING THE TROLL MODE
(Remote control model: Option Item,
Tiller handle model: Standard Item)
On the remote control model, trolling speed can
be controled to install the optional Troll Mode
switch.
Please contact your authorized Suzuki Marine
Dealer for more information.
NOTE:
To monitor engine speed correctly during the
troll mode operation, Suzuki recommends the
use of the Suzuki 2-scale Monitor Tachometer.
(Remote control model)
System Outline
The "Troll Mode System" is activated by press-
ing the troll mode switch, when the motor is run-
ning at in-gear idle speed. By using this system,
you can set and maintain a desired engine
speed with the control switch in a range from
in-gear idle speed (approx. 800 r/min) to 1200
r/min.
How to use the Troll Mode
Setting the troll mode:
1. Shift into forward or reverse gear and make
sure that the throttle is fully closed (in-gear
idle speed).
2. Press the "UP" or "DN" position of the troll
mode switch, until you hear one beep.
On the remote control model, the REV/TRL
(or REV) lamp on the monitor gauge will
flash indicating that the motor has been set
to the troll mode. The REV/TRL (or REV)
lamp will continue to flash while the motor is
in the troll mode.
Usual scale
Trolling mode scale
41