Idiomas disponibles
Idiomas disponibles
NOTE:
A spare plastic lock plate is provided for tempo-
rary use only. Remove it from the cord and
place it in a safe place on board your boat. If
you lose or break the emergency stop switch
cord/lock plate assembly, replace it as soon as
possible so that you can resume normal use of
the emergency stop switch.
6. Set the release lever 2 to the "Lock" posi-
tion. (DF40AQH model)
STARTING THE ENGINE
V WARNING
Exhaust gas contains carbon monoxide, a
dangerous gas that is difficult to detect
because it is colorless and odorless. Breath-
ing carbon monoxide can cause death or
severe injury.
Never start the engine or let it run indoors or
where there is little or no ventilation.
NOTE:
If the emergency stop switch lock plate is not in
position, the starter motor cannot operate.
36
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
2. Remote control model:
Make sure that the warm-up lever is in the
fully closed position
Tiller handle model
Make sure that the throttle control grip is in
the fully closed position.
3. Turn the ignition key to the "ON" position.
4. Turn the ignition key to the "START" position.
After returning the ignition key to "ON" posi-
tion from "START" one, starter motor con-
tinue to turn for 4 seconds until engine start.
.
:
