Prusa Research MMU3 Manual Del Usuario página 35

PASO 11 Idler Body parts preparation
Para los siguientes pasos, por favor prepara:
Motor tensor (1x) (el que tiene el eje corto)
Cuerpo Tensor (1x)
Tornillo M3x10 (5x)
Tuerca M3nS (1x)
Silicone stopper (1x)
Eje 5x16sh (1x)
PASO 12 Silicone stopper instalation
Orient the Idler body as seen in the picture.
Insert the silicone stopper into the small opening on the Idler body.
Push it in and keep it pressed with your finger until you feel it fully engage into the
opening. If it doesn't engage, try cleaning up the opening with an Allen key and
rotating the stopper while inserting.
Verify it is seated properly and won't fall out.
The top part should be flush and there should be bottom part of the stopper visible
from the side.
4. Montaje del cuerpo del tensor
Ensamblaje Original Prusa MMU3 35