Prusa Research MMU3 Manual Del Usuario página 94

PASO 11 Partial extruder disassembly
Reach for the hotend and incline its upper part towards the motor. Wiggle it to slide
it down.
If the hotend is still stuck inside, release the screws below the motor some more to
increase the gap between the printed parts.
BE EXTRA CAUTIOUS with the hotend cables!!! You can break them! Use a
reasonable force to pull the hotend out. Don't bend the cables too much.
PASO 12 Tubo PTFE: preparación de las piezas
Para los siguientes pasos, por favor prepara:
Hotend PTFE tube (1x)
PTFE for MK3S+ is 42.3mm long, 1.85mm ID, 4mm OD, inner chamfer on one
side, outer chamfer on the other.
The bundled PTFE tube is intended for MK3S+ only. The
and MK3S+
94
9B. Mod extrusor MK3S+ (KIT)
differ in length.
Ensamblaje Original Prusa MMU3
PTFE tubes for MK3S