Tabla de contenido
PASO 19
Turning the MMU on and reset
After finishing the firmware update, make sure there are no filaments loaded
neither in the extruder, or in the MMU unit.
Navigate to the LCD menu > Settings > MMU
and make sure it is set to MMU [On]
Hit the reset button on the printer's LCD box.
From now on, the reset button on the printer resets also the MMU unit. Wait for a
while, the MMU unit will go through the self-test routine. (accompanied by flashing
LED lights on the MMU unit) Wait until it boots up properly, before issuing any
commands to the printer.
In case of necessity, the reset button is also useful to help you get out of some
unrecoverable situations even for the MMU unit. But remember, it also aborts an
ongoing print immediately.
134
10B. Configuración y Calibración MK3S+
Ensamblaje Original Prusa MMU3
Tabla de contenido
