Prusa Research MMU3 Manual Del Usuario página 86

PASO 14 Finishing up the Spoolholders (inj. mol.)
Desliza las partes laterales sobre la parte Guía.
Repeat the same steps for the remaining Spool holders, until you assemble all five.
(Don't forget about the foam pads on the bottom!)
PASO 15 Joining the Spoolholder Guides
There are protrusions on each side of the Guide part.
Using these protrusions, the Guide parts can be joined together. To join them
together, simply tilt in the Guide parts one into the other until the protrusions click
in.
The Guides can be joined together in form of a straight line.
Or, if you flip one of the Guides around, they can be joined in an arc pattern. This is
handy to form an arc of spool holders around the Buffer so that each filament path
is as straight as possible.
86
8. Montaje Porta bobinas
Ensamblaje Original Prusa MMU3