Tabla de contenido
PASO 7
Electronics wiring diagram MK3S+
In the following step, we will connect the cables to the already existing connections
on your Original Prusa MK3S+. Please, proceed very carefully.
Follow the diagram shown here in case you need to reconnect any of the extruder
cables into the Einsy Rambo control board.
Since, MK2.5S printer isn't officially supported in combination with the MMU3, this
guide doesn't cover connecting the electronics on it. Instead, it is described in the
MK2.5S MMU2S guide.
PASO 8
Connecting the data and FS cables
Note the marked position. The MMU Signal cable connector should go here. (upper
row of the pins, brown wire in the plug must be facing left)
Upper row of the pins, the brown wire in the plug must be facing left!
El cable del sensor de filamento IR está justo debajo del cable de señal de la MMU.
Bottom row of the pins, the white wire is facing left.
Verify the IR Filament sensor connector is installed correctly. Make sure it is
plugged in correctly as there are several ways for it to go wrong!
¡Asegúrate de que el cable de señal está conectado adecuadamente a todos los
pines!
10B. Configuración y Calibración MK3S+
Ensamblaje Original Prusa MMU3
127
Tabla de contenido
