Tabla de contenido
PASO 7
Test de Carga (parte 1)
Go to the Menu > Settings > Loading Test
Select the filament type to preheat (PLA)
Select Load all.
The MMU unit will now load and then unload all five filaments to see if all work
correctly.
PASO 8
Test de Carga (parte 2)
While your MK3S+ loads a filament into the extruder, it performs the loading check:
Solid blocks should be generated on the bottom of the LCD representing the IR
filament sensor detecting a filament during the process.
If there are lines instead of some of the solid blocks, it means the Filament
sensor in the extruder is providing an intermittent reading and might require
some aditional tuning.
En caso de que fallen varios reintentos de carga, aparecerá una
error
correspondiente.
11. Primer comienzo
Ensamblaje Original Prusa MMU3
pantalla del
149
Tabla de contenido
