Tabla de contenido
PASO 37
Attaching the hotend cables
Push two zip-ties through the upper slots on the cable-holder. Tighten the zip-ties
up slightly around the hotend cables.
Arrange the cables from the hotend into the dedicated channel on the bottom.
Tighten up the zip-ties and cut the remaining parts of the zip-ties.
PASO 38
Attaching the cable bundle
Let's move onto the electronics box side of the cable bundle.
Tighten up the sleeve around the cable bundle. Hold it tight before you fix it in
place with the clip and the screws. The textile sleeve should be held by the cable
clip
Fix the cable bundle in place by tightening the two M3x10 screws holding the
Extruder-cable-clip. Make sure no cable is getting pinched!
For easier cable-management inside the electronics box, attach the extruder cable
bundle to the hooks on the inside of the Einsy-base with two zip-ties in the marked
positions.
9B. Mod extrusor MK3S+ (KIT)
Ensamblaje Original Prusa MMU3
107
Tabla de contenido
