Paso 5 Trimming The Electronics Box Door; Paso 6 Trimmed Electronics Door Installation - Prusa Research MMU3 Manual Del Usuario

PASO 5 Trimming the electronics box door
WARNING: We need to cut part of the plastic on the electronics box door to make
some room for the MMU's cable. Make sure you wear protective eyewear!
If you're upgrading from the MMU2S to MMU3 and your door has been trimmed
already in the past, you can skip this step.
Release and remove the M3x10 screw in the upper hinge. Remove the door together
with the hinge by pulling it up.
Using pliers, carefully cut the inner corner of the door. The MMU cable bundle will
need some more clearance in the marked location.
Comparison between the trimmed door (left) and its original shape (right).
PASO 6 Trimmed electronics door installation
Re-attach the door back onto the bottom hinge.
Make sure the top hinge is in place.
Attach the top hinge to the printers frame using the M3x10 screw.
Make sure there is enough clearance for the MMU3 cable when you close the door.
The cable should be held by the door but must not be squished too much.
Otherwise, you risk damaging the cable!
126
10B. Configuración y Calibración MK3S+
Ensamblaje Original Prusa MMU3