Scheppach HS110 Traduccion Del Manual De Instrucciones Originale página 33

31. Transverse stop with knurled nut (i)
32. Sight glass
32a. Sight glass screw
3. Scope of delivery
• Table saw with pre-mounted 24 tooth saw blade
• Saw blade guard
• Riving knife
• Parallel stop
• Stop rail
• Transverse stop
• Table width extension (2x)
• Push stick
• Pillars (4x)
• Centre struts (4x)
• Rubber feet (4x)
• Stand bracket (2x)
• Table supports (4x)
• Manual
• Hexagon head screw with cross slot with mounted
U-washer / spring washer 16 units (a)
• Carriage bolt, 20 units (b)
• U-washer, 20 units (c)
• Spring washer, 12 units (d)
• Nuts, 28 units (e)
• Ring spanner SW 10/22 (f)
• Open-end spanner SW 10 (g)
• Allen key HX 6 (h)
• Hexagon head srew (k)
4. Intended use
The table circular saw is used for cutting all types of
wood lengthwise and crosswise (only with the trans-
verse stop), depending on the machine size. All types
of round timbers must not be cut with it.
The machine may be used only for its prescribed pur-
pose. Any other use beyond that is considered to be
not in accordance with the designated purpose. The
user/operator is liable for all types of resulting damage
or injury and not the manufacturer.
The only saw blades which may be used are those
which are suitable for the machine (HM or CV saw
blades). The use of any type of HSS saw blades and
cutting discs is prohibited.
Use in accordance with the designated purpose is also
deemed to include observance of the safety instruc-
tions, as well as the assembly and operating instruc-
tions in the operating manual.
Individuals who operate and maintain the machine
must be familiar with it and must have been instructed
in possible hazards. Moreover, the latest accident pre-
vention regulations must be strictly observed.
Other general rules in the fields of occupational health
and safety technology must be complied with.
m Caution!
When using equipment, certain safety precautions
must be complied with in order to avoid injuries and
damage. You should therefore read these operating in-
structions / safety instructions carefully. Keep these in
a safe place so that the information is available to you
at all times. Should you give the device to anyone else,
please give them these operating instructions / safety
instructions as well. We assume no liability for acci-
dents or damage caused by failure to observe these
instructions or the safety instructions.
Changes to the machine will cause the manufacturer's
liability with respect to any resulting damage to be com-
pletely excluded.
Even when the device is used in accordance with the
designated purpose, it is nevertheless not possible to
completely eliminate certain residual risk factors.
Due to the design and structure of the machine, the
following risks may occur:
• Touching the saw blade in the area of the saw which
is not covered;
• Reaching into the running saw blade (cuts)
• Kickback of workpieces and workpiece parts.
• Saw blade breaks.
• Ejection of faulty hard metal parts of the saw blade.
• Hearing damage if the necessary hearing protection
is not used.
• Emissions of wood dust which are harmful to the
health when used in closed rooms.
Please note that the use of our devices in accordance
with the designated purpose does not include commer-
cial, handicraft or industrial applications. We assume
no warranty if the device is used in commercial, handi-
craft or industrial businesses or for equivalent purpos-
es.
www.scheppach.com GB | 33