Bench Mounting - Makita LS1017 Manual De Instrucciones

COMPLIES WITH 21CFR 1040.10 AND
1040.11
AVOID EXPOSURE – LASER RADIATIONS
IS EMITTED FROM THIS APERTURE
CONFORME A 21CFR 1040.10 ET 1040.11
EVITEZ L'EXPOSITION - UN
RAYONNEMENT LASER EST EMISPAR
CETTE OUVERTURE.
CAUTION /PRECAUCIÓN
LASER RADIATION DO NOT STARE IN TO BEAM
RADIACIÓN LÁSER NO DIRIJA LA
VISTA HACIA EL RAYO LÁSER
Maximum Output
<1mW, Wavelength : 650 nm
CLASS LASER PRODUCT
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
no load speed
alternating current
Class II Construction
revolutions or reciprocation per minute
Do not place hand or fingers close to the
blade.
INSTALLATION

Bench mounting

1
► 1 . Stopper pin
When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. Release the stop-
per pin by simultaneously applying a slight downward
pressure on the handle and pulling the stopper pin.
WARNING:
Ensure that the tool will not move on the
•
supporting surface. Movement of the miter
saw on the supporting surface while cutting may
result in loss of control and serious personal
injury.
1
► 1 . Bolts
This tool should be bolted with four bolts to a level and
stable surface using the bolt holes provided in the tool's
base. This will help prevent tipping and possible injury.
Installing the holders and holder
assemblies
NOTE: In some countries, the holders and holder
assemblies may not be included in the tool package
as standard accessory.
3
1
► 1 . Holder 2. Holder assembly 3. Screw
The holders and the holder assemblies support work-
pieces horizontally.
Install the holders and the holder assemblies on both
side as shown in the figure.
Then tighten the screws firmly to secure the holders and
the holder assemblies.
6 ENGLISH
1
2