Idiomas disponibles
Idiomas disponibles
Operation
Plate Dispenser Adjustment
Adjust retaining bolts
Figure 16
§
If it is necessary to alternate between the rows of holes in the plate dispenser model 27-33 (except
TEUH-2VC27-33), the upper holders of the crockery guides must also be inserted into the available
holes. When using TEUH-2VC, the holders of the crockery guide will be fitted respectively on to the
other retaining bolts (B).
§
Remove the crockery guides in the area of the retaining bolts (B) by pressing them down slightly and
fit them onto the other retaining bolts (B).
NOTE
5.2.2
Spring adjustment
ATTENTION
ATTENTION
NOTE
4330000_A6
TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
Retaining bolts
Crockery diameters
The following crockery diameters can be set with the locking positions provid-
ed:
Plate dispenser Type 19-26: 7.48'' / 8.46'' / 9.25'' / 10.24'' (the first row of
holes)
Plate dispenser Type 27-33: 10.63'' / 11.81'' / 13'' (the first row of holes)
11.02'' / 12.6'' (the second row of holes)
Damage to persons and property due to improper adjustment
When the dispensing height is exceeded, there is a risk of accident or injury
due to tipping of the crockery stack and breakage of dishes. If the level falls
below the dispensing height, injuries to the fingers due to squashing can oc-
cur when removing dishes.
Adjust appropriately the dispensing height by hooking or unhooking the
springs. When adjusting springs on sharp edges, pay particular attention to
the ends of the tension springs. Act carefully.
Risk of injury
Be careful when hooking and unhooking the springs.
When adjusting springs on sharp edges, pay particular attention to the ends of
the tension springs.
Guide basket
It is not necessary to dismantle the guide basket in order to adjust the springs.
It should only be dismantled by specialist staff and, moreover, it is not possi-
ble do this from above without a tool.
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26
Chapter 5
Page 29
Plate dispenser
