Adjusting The Chassis; Handlebar Position - SHERCO 450 SEF RACING Manual Del Usuario

ADJUSTING THE CHASSIS

HANDLEBAR POSITION

A
B
110
The triple clamps have two holes separated by a
distance A.
Distance between holes A
The handlebar clamps are offset by a distance B.
Handlebar offset B
The bike comes standard with the handlebars in the
rear most position.
Remove the four screws
top clamps and remove the handlebar.
Remove the two screws . Remove the lower clamps
and place them in the desired position.
Handlebar
lower clamp
Replace the handlebars and top clamps.
Replace the four screws
Handlebar clamps
fixing screws
The handlebars can be rotated forward and rearward
in the clamps.
1
2
13mm
. Remove the handlebar
1
2
M10x35 40Nm Loctite
and tighten evenly.
1
M8x25
4mm
®
243™
25Nm