TRAPP TR-600 Manual De Instrucciones página 88

Remove locking screws (4).
 
Turn the rotor (1), bringing blades (2) near
 
the counter-blade (3).
Adjust the position of counter-blade (3)
 
with adjustment nut (5), allowing a distance
between blade and counterblade between
2.8 mm (0.110.") and 3.5 mm (0.138.").
Make sure the distance is the same for all
 
blades.
Lock adjustment nuts (5) and tighten securing
 
screw (4) with a torque wrench, as shown in
table "Torque Specifications".
1
2
5
4
3
Check belt stretching
Belts are provided with an automatic stretcher,
spring, which needs to be checked. To either
increase or decrease belt stretching, do as
follows:
Stop the machine.
 
Remove ignition key and disassemble
 
cardan.
88
2.8 - 3.5
Remove screws from both transmission
 
protections - upper and lower.
Remove both protections.
 
Use nuts (A) and threaded rod (B) to stretch
 
or loosen spring (C), pressure of 9 kg (20 lb).
If necessary, replace spring, but first
 
disassemble the threaded rod.
Place the new spring and apply the correct
 
pressure.
Replace the two belt protections, and tighten
 
screws.
C
B
A
Battery
The TR-600G is provided with a system
sufficiently charges battery for normal use.
You can extend battery life by periodically
charging it with an automotive charger.
Always keep battery and terminals clean.
 
Keep battery screws tight.
 
Recharge battery with 6 to 10 A for one
 
hour.
www.trapp.com.br
FORCE
9 kg
that