Checking Battery; Belt Adjustment - TRAPP TR-600 Manual De Instrucciones

www.trapp.com.br

Checking battery

Remove closing protection (1) and loosen battery
securing bar (2). Remove battery from base (3),
check for charge in the viewer.
Note:
When replacing battery on the
 
base, make sure to properly connect
cables.
Red cable: (+) Positive
O 
Black cable: (-) Negative
O 
Frequently check belt pressure. The belt is
 
located under the side guard. Unscrew guard
to check belt pressure. If necessary, adjust
it or replace it. When belt pressure is not
enough, its life is compromised.
Belt pressure for shredders TR-600E and
 
TR-600G is adjusted through the stretching
roll - under belt side guard.
To start the motor, lever (1) must be in
 
position (A) when the motor reaches
maximum revolution; slowly unlock lever to
position (B).
Do not operate shredder without belt
 
protection guard.
 
3
3
 
2
2
3
2
1
1
 
1

Belt Adjustment

Attention!
If equipment is not used for more than 30
(thirty) days, you may run out of battery.
To prevent corrosion and loss of power
during long storage, disconnect battery
cables.
Disconnected cables must not get in
touch with battery terminals.
1
1
1
A
A
A
B
B
B
1
1
1
A
A
B
B
A
B
79