TRAPP TR-600 Manual De Instrucciones página 69

www.trapp.com.br
TRAPP shredders, either single-phase or
 
three-phase, are assembled with dual voltage
motors. They leave factory without electric
wiring so customers can choose the one that
best suits their voltage needs.
For shredders sold without the motor, choose
 
minimum power according to technical data
under "Technical Characteristics."
For motors of power above 5 cv, the use of a
 
delta-star switch is recommended. The model
suggested is ETW (WEG Acionamentos) or of
similar type.
As the on/off switch is distant from the
 
shredder, install an emergency button in the
equipment in case immediate switching off is
necessary.
Supply
Avoid using gasoline stored for more than 7
 
days, as this causes malfunction decreasing
motor life .
Fill the tank being careful not to spill fuel.
 
Installation of Electric Motor
Installation of Gasoline Motor
Attention!
Before making any kind of connection,
 
be sure the power source is
disconnected.
Make sure the power source where the
 
shredder will be installed is compatible
with the data on the motor plate.
Make the connections shown according
 
to the voltage of the power source.
Use insulating tape on the connections
 
made to protect them.
Make sure connections are well
 
insulated.
Turn on power source and check the
 
rotation of the motor.
Refuel only with plain (no additives) gasoline.
 
Note the capacity of the fuel tank, amount
 
and type crankcase oil (see "Technical Data")
Note: for further information on operation please refer
to the engine manual.
69