TRAPP TR-600 Manual De Instrucciones página 65

www.trapp.com.br
Note:
According to Brazilian standard NBR
5410, the installation of a device to protect
against residual differential current (RD
device) in the electrical installation of your
residence is compulsory. The function of the
"DR" is to protect the user against serious
electrical shock risk (consult an electrician).
Additional Safety and Operation Instructions
Carefully read instructions and get familiar
 
with the controls and proper used of the
equipment.
Remember that the operator or user is
 
responsible for any accident or damage
involving people or their properties.
Do not operate the equipment barefooted or
 
with sandals. Always wear adequate shoes
and pants, goggles, gloves and ear plugs.
Avoid operating the equipment in humid
 
places. Use the equipment in a well lit
environment.
Wear gloves to introduce residues material
 
in the shredder. Use a long piece of wood to
push small pieces.
Before feeding any kind of foliage, start the
 
motor and wait for it to reach maximum
revolution.
Do not introduce anything in the equipment
 
with the motor off.
Never operate the shredder with the cover
 
open or without the belt protection guard.
Attention!
Do not use a water jet to clean the
equipment. Use a cloth soaked in mild
detergent. Water inside the equipment can
damage the winding.
5 - Service
Call a qualified professional to service
 
the equipment. Use original parts
only. Always call TRAPP Authorized
Service Technicians. TRAPP is not
responsible for occasional accidents
caused by the use of spare parts that
are not original.
If the equipment starts to vibrate, turn it off
 
immediately. Check the cause of vibration as
it indicates the equipment needs adjustment
or repair.
Make sure the voltage of the power source is
 
the same of that of the equipment.
Do not use the equipment during periods of
 
power supply failure.
Check power supply cord. Do not mend it
 
with insulating tape.
If the motor does not start (locked),
 
immediately switch it off.
Should any anomaly be observed during
 
operation, switch the shredder off. Look for
TRAPP nearest authorized assistance.
This equipment is equipped with a
 
combustion motor - 4 times (TR-600G). Uses
no oil in the gasoline.
The motor is shipped from factory without oil
 
and without fuel (TR-600G).
If potentially dangerous situations are
known, accidents can and must be avoided!
65