Bosch MUM58M59 Instrucciones De Uso página 27

Important information concerning the
use of the whisk (Figure D):
The whisk should almost touch the bottom
of the bowl to ensure that the ingredients
are optimally mixed. If not, adjust the height
of the whisk as follows:
■ Remove mains plug.
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the whisk into the drive
until the whisk locks into position.
■ Hold whisk in place and loosen nut
clockwise using open­ended wrench
(size 8).
■ Set the whisk to the optimum height by
rotating the whisk:
– Turn clockwise: Raise
– Turn anti­clockwise: Lower
■ Press the Release button and
move the swivel arm to
position 1.
■ Check the height of the whisk
and, if required, correct.
■ When the height has been set
correctly, press Release button
and move the swivel arm to
position 2.
■ Hold whisk in place and tighten nut
anticlockwise using open­ended wrench
(size 8).
Working with the bowl and the tools
Fig. E:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Depending on the processing task,
insert the stirrer, whisk or kneading hook
until it locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig. E-4b).
■ Put the ingredients to be processed into
the bowl.
■ Press the Release button and
move the swivel arm to
position 1.
■ Attach the cover.
■ Set the rotary switch to the desired
setting.
Adding more ingredients
■ Switch off the appliance with the rotary
switch.
■ Add more ingredients through the feed
tube in the cover.
or
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Add ingredients.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Remove mains plug.
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see "Cleaning and
servicing".
Continuous-feed shredder
Observe the application examples in
table M
W Risk of injury
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuousfeed shredder, wait until the
drive has come to a standstill and pull out
the mains plug. Do not reach into the feed
tube.
Operation en
27