Corghi 601 Manual De Uso página 57

Idiomas disponibles

Note

1. Fix the wheel balancer after removing it from its packing.

2. Set the grounding line.

3. Do not move the main shaft and avoid any breakage.

4. Avoid humidity and vibration effects.

5. It is advisable to use a stable power supply.

PRESETTING THE THREE

STORED DATA VALUES

Note: this function can be used only when the balancing nuts are not precise and stable

even after calibration. When these three values are being adjusted, remove the 100-g

weight, perform calibration after setting each of the three values to store them in the

computer, otherwise this function will not be effective. Remove the weight tray and

consult the original data indicated inside the machine for setting.

1) SFA data adjustment: after calibration, if the 100-g weight is not positioned directly

under the wheel-holder shaft (six o'clock position) or if data are not correct, this function

can be used to determine the weight offset value. Remove the weight, then press the

and

"A"

button, then rapidly the value "A"

press the

the values; it is not necessary to pay attention to them; press the value "A"

ton again (the

is displayed on the left, the corresponding value is displayed on the right; then press

the value "A"

100-g weight position. If the data is to be modiﬁed, press the value "L"

button to adjust the 100-g offset value, then press the value "A"

Repeat calibration. Sometimes the SFA value must be re-adjusted until the 100-g weight

is not positioned directly under the wheel-holder shaft.

2) "dis" value adjustment: this function is used for solving the internal unbalance value

problem.

Balance the wheel and apply a 100-g weight on the outside of the tyre. The value dis-

played ranges between 104 and 96. Move the 100-g weight to the inside of the tyre. After

stopping, the value ranges between 104 and 96, i.e. normal value. If not, the operator

should adjust the "dis" value; the adjusting procedure is the same as that used for the

Operator's manual @ 601

button; indicators stop ﬂashing after nine seconds; press the value

button; the left indicator displays "dis", the right indicator displays

button now allows the operator to go to the next program); "In-l"

button to go to the SFA window. The right indicator displays the

button. When all indicators are off,

but-

button to exit.