No visualization on the display after switching on
External power supply malfunction
Check the external power supply
➥
Power supply card malfunction
Replace the power supply card.
➥
Loose connection between the computer and power supply cards
Check the connector on the connection line
➥
Computer card malfunction
Replace the computer card
➥
The display is normal, but the start switch and buttons A, L and D
Loose connection between the computer and power supply cards
Secure the connection line between the computer and power supply cards
➥
Computer is out of service
Re-start the machine
➥
The display is normal, but the brake is not working
Incorrect switch connection
Open the cover and secure the touch-sensitive switch connector
➥
Power supply card malfunction
Replace the power supply card.
➥
Computer card malfunction
Replace the computer card
➥
The machine start-up takes a long time, the brake is not working
The machine body is positioned on an unstable plane
Solve the problem according to the test results
➥
Cone or quick fixing cap effect
Re-tighten the quick fixing cap.
➥
The wheel is not mounted correctly
Check the power supply.
➥
The power supply inside the machine is unstable
The operator can regulate the power supply.
➥
Power voltage fluctuates considerably
Replace the computer board if necessary.
➥
Calibration value has changed
Re-calibrate according to the User's Manual.
➥
Value inside the machine has changed
Enter the dis, In-I and SFA data again according to the instructions on the ma-
➥
chine, then calibrate again to make sure that the machine is working correctly
56
TROUBLESHOOTING
for data entry are not working
and balancing is not accurate.
Operator's manual @ 601