Idiomas disponibles
Idiomas disponibles
Airfusion Climate Installation Instructions
Remote Control Buttons
○
1 - FAN SPEED CONTROL BUTTON:
There are 6 available speeds.
○
speed, and
VI button is for the fastest speed.
NOTE: when you turn on the fan for the first time or switch the
main power to the controller, you need to start the fan on hight
○
"
VI " speed first and then choose a lower speed. A 5-10
seconds is required to allow the DC fan to respond to the
remote each speed or fan direction seletions, as DC fans
incorporate a sensor control which controls the power to the
motor.
○
2 - FAN OFF BUTTON:
Press the button to turn the fan off.
○
3 - REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running function. The fan must be operating to activate the reverse function.
○
4 - LIGHT CONTROL BUTTON:
Press the button to turn on/off the light.
THE RECEIVER PROVIDES THE FOLLOWING LEVEL OF PROTECTION:
Lock position: the receiver has a built in safety feature to protect against obstruction during operation. The motor
will be locked from operation and will disconnect from power after 30 seconds of interruption. Please remove
obstacles before re-starting. To reset, simply turn off the power supply to the fan motor and re-start.
Over 80W protection: when the receiver detects power consumption which is greater than 80W, the receiver power
will be stopped and operation will immediately discontinue. Turn the receiver power on after 5 seconds to restart the
fan.
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC ceiling
fan remote and receiver.
Issues:
Loss of control - Fan is only running at high speed after installation
Loss of control - No reverse function after installation
Loss of control - Remote cannot communicate with receiver
Solution:
If the fan runs at the highest speed continuously, it means the wiring of the installation is correct. When the fan operates
10 | P a g e
○
button is for the lowest
I
Fig. 12
