Idiomas disponibles
Idiomas disponibles
Airfusion Climate Installation Instructions
The fan operates at highest speed in REVERSE mode automatically for approximately 2 minutes and then operates
in FORWARD mode for approximately 2 minutes. During the paring process, DO NOT TOUCH THE REMOTE FOR
4-5 MINUTES.
Now the transmitter should be paired with the receiver of ceiling fan 1. Turn ON/OFF or change the speed of ceiling
fan 1 by the transmitter to check the operation.
Setting DC Ceiling fan 2:
Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
Slide the cover of the battery compartment of the transmitter to access the DIP switches. This will be transmitter 2.
Change the position of the DIP switches in the remote transmitter 2, so that it will be different to transmitter 1. Fig.
11
Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own isolation
switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
Press and hold the SET button of transmitter 2 for 8-10 seconds within 60 seconds of switching the power to the
receiver of ceiling fan 2.
If the fan has light kit attached, the light will flash on and off to indicate the paring process activated.
The fan operates at highest speed in REVERSE mode automatically for approximately 2 minutes and then operates
in FORWARD mode for approximately 2 minutes. During the paring process, DO NOT TOUCH THE REMOTE FOR
4-5 MINUTES.
Now the transmitter should be paired with the receiver of ceiling fan 2. Turn ON/OFF or change the speed of the
ceiling fan 2 by the transmitter to check operation.
Note: The pairing of Transmitter and Receiver is not required if only one ceiling fan is installed.
When more than two ceiling fans are installed near each other, please refer to the instruction
above.
9 | P a g e
Fig. 11
