Idiomas disponibles
Idiomas disponibles
ROBO Compact W500 / W600
6.3.1 Connecting and adjusting the shielding gas volume
NOTICE
• The type and volume of the shielding gas to be used depends on the welding task and the
gas nozzle geometry.
• Establish all shielding gas connections so that they are gas-tight.
• To prevent blockages caused by contamination in the shielding gas supply, you must
quickly open the cylinder valve before connecting the supply. Doing so blows out any
contamination.
1 Connect the shielding gas cylinder to the wire feeder system.
2 Set the gas volume on the shielding gas cylinder's pressure reducer.
3 Attach the shielding gas connector as appropriate for the relevant version (Euro CC,
Panasonic
6.3.2 Connecting the control lead
On the torch
Emerg. stop 2
Emerg. stop 3
Emerg. stop 1
Trigger
Trigger
Current sensor
Gas nozzle sensor
* only connected in the case of cable assemblies with an emergency stop function
Fig. 6
Connecting the control lead
The control lead on the machine is open. The customer must connect a suitable plug. If all data
is provided, the system will be supplied ready for connection. Otherwise, choose a plug that is
compatible with your power source and connect it to the corresponding leads according to the
terminal diagram.
®
connector).
7-pole control lead
100.0084
WH
BN
GN
YE
GY
BU
PK
6 Putting into operation
On the machine
B*
C*
A*
n.c.
n.c.
n.c.
n.c.
EN - 15
