Idiomas disponibles
Idiomas disponibles
3.
The nozzle will come out without spraying any water.
4.
Remove the tip by rotating it in an anti-clockwise direction.
5.
Clean the nozzle.
6.
Clean the tip.
7.
Place again the tip on the nozzle.
8.
Once the cleaning is finished, press the Stop button on the remote control or the auxiliary
side control. Should you fail to do so, the nozzle will move backwards automatically after
5 minutes. Once inside, it carries out a self-cleaning process.
▌
4.4 AUTOMATIC DESCALING PROCESS
5 s.
1.
Assembly the beaker parts.
2.
Place the beaker in vertical position and fill it up to the mark inside.
3.
Pour the CONTENT of the descaling sachet (ref. A805072002) into the beaker and mix
it slightly.
4.
Manually lift the nozzle door and introduce the beaker neck inside. Make sure that it
securely rests against the porcelain.
5.
Press for 5 seconds the rear wash button on the auxiliary side control to move the nozzle out.
6.
Press for 5 seconds the drying button on the auxiliary side control to start the automatic
descaling process. The process will take approximately 30 minutes. Do not remove the
beaker while the process is going on.
7.
Once the descaling process has finished, the nozzle automatically will move inside, and
two sort "beeps" are emitted. Remove the beaker from its position and the product will be
ready to be used again.
It is recommended to descale the product at least once a year, or if it is detected that the flow
of washing water has been reduced considerably. In geographical areas with very hard water,
a higher frequency may be recommended.
Fill to mark inside
5 s.
45
30 min.
x2
