Idiomas disponibles
Idiomas disponibles
IMPORTANT:
1.
Do not use aggressive products such as bleaches or ammonia. Use only neutral product.
2.
Do not pull or push the nozzle manually. To remove it see section 4.2
3.
While cleaning the WC leave the cover open for a few hours so that gases do not enter
the In-Wash Insignia.
4.
Do not spray the water or the air outlets with water or cleaning agents that may enter
inside the In-Wash Insignia.
▌
4.2 CLEANING MODE
The In-Wash Insignia has a Cleaning Mode. This mode allows to disable all the automatic
functions so the product can be cleaned comfortably.
To activate the Cleaning Mode:
3 s.
1.
Press for 5 seconds the "Hygienic Flush" button of the auxiliary side control on the e-bidet.
2.
A long "beep" is heard and the e-bidet LEDs blink while the mode is active, deactivating
the rest of the functions and buttons.
3.
All functions of the In-Wash Insignia are then disabled for 5 minutes to clean it comfortably.
4.
Once the cleaning has been carried out, press the Stop button on the auxiliary side
control. A beep is heard and the In-Wash Insignia performs a self-cleaning of the nozzle.
5.
If the Stop button is not pressed, all the functions are automatically re-enabled after 5
minutes and a self-cleaning of the nozzle is carried out automatically.
▌
4.3 CLEANING OF THE NOZZLE / TIP REPLACEMENT
We recommend cleaning the nozzle and the tip weekly.
To remove the nozzle follow this steps:
3 s.
1.
Press the anal cleaning button on the auxiliary side control for 3 seconds.
2.
The lights blink and a beep can be heard (if the silence mode is not activated).
x1
x1
44
5 min.
5 min.
ó
