Idiomas disponibles
Idiomas disponibles
▌
3.5 RETURN TO DEFAULT SETTINGS
To return to the factory settings carry out the remote control linking process (see section
2.4.1)
All previously modified values will be deleted and the In-Wash Insignia will have its default
settings:
•
Medium water and drying temperature.
•
Medium pressure.
•
Middle position.
•
Light mode 1 (standard).
•
It will also carry out a product self-calibration test, in which water flows out of the nozzle
for 2 minutes.
•
Silence mode disconnected.
▌
3.6 TURNING OFF (STAND-BY) / RESET OF THE PRODUCT
To switch off the In-Wash Insignia, press the Stop
button on the auxiliary side control for 3 seconds.
To reactivate the In-Wash Insignia, press the Stop
button on the auxiliary side control.
From that moment on the device carries out a
power self-calibration for 2 minutes; during this
period of time water flows out of the nozzle.
Do not disconnect the device during this process.
4. CLEANING AND MAINTENANCE
▌
4.1 GENERAL CLEANING
CLEANING OF THE REMOTE CONTROL
Clean the remote with a damp soft cloth.
If the remote control is very dirty, you may use diluted neutral detergent.
Do not remove the cover of the batteries during its cleaning.
CLEANING OF THE DEVICE
Clean the outside of the device with care using a soft and damp cloth or a sponge.
Hard
Cl
neutral
soft
43
3 s.
