Idiomas disponibles
Idiomas disponibles
2. INTRODUCTION
▌
2.1 PRODUCT PARTS
See fig. 1 for details of the parts.
This product incorporates the electronic equipment with ref. A804200Y..., composed of In-
Wash (ref. A805050000), In-Wash remote control (ref. A805059010), In-Tank (wall hung ref.
A806003... , floorstanding ref. A806004.... ), and In-Tank remote control (ref. A805059300).
▌
2.2 START-UP
The remote control and the flush remote control control are linked at the factory. To start up
the product follow the steps described below:
CR 2032 (x2)
1.
Place the batteries inside both remote controls.
2.
Open water supply valve
3.
Activate the power to supply the In-Wash Insignia.
If the remote controls need to be linked again, follow the steps of linking process of the remote
controls (see section 2.4)
2.2.1 USE OF THE PRODUCT
When the product is first connected to the mains, it is necessary to wait at least 4 minutes to
be able to perform the first discharge of the toilet.
The In-Wash Insignia has a small internal water tank that is cold in stand-by conditions.
When the user detector detects a seated user, the preheating process is activated.
The preheating takes place at 36º. The functions may be activated at any time, but if they
are activated too soon, the water will not have time to reach the established temperature;
therefore it is recommended a minimum preheating period of 30 seconds from the moment the
In-Wash Insignia detects the user until any water function is activated.
When a function is activated, the In-Wash Insignia carries out a cleaning of the nozzle before
its use.
When the function is finished and the user leave the toilet, a subsequent cleaning process of
the nozzle takes place for 10 seconds.
1
CR 2032 (x1)
2
33
3
ON
