Idiomas disponibles
Idiomas disponibles
COMPONENTS
CONTROL PANEL COMPONENTS
1
1. Push-Button START/STOP: Push once to
automatically start the engine. Push again to stop
the engine.
2. Battery Switch: Turns battery ON and OFF. Must be
ON before electric or remote start.
3. Data Center: Toggle to show voltage, frequency,
total hour meter, and run/maintenance timer.
4. Main Circuit Breaker: The main circuit breaker
controls total output of all outlets to protect the
generator from overload or short circuit.
5. Voltage Selector Switch: Select 120 Volts or 240
Volts. Shut the generator OFF before switching
voltages.
6. 120/240 Volt AC, 30 Amp NEMA L14-30R Twist-
Lock Receptacle: Receptacle can supply a
maximum of 30 Amps
7. 120 Volt AC, 30 Amp NEMA TT-30R Receptacle:
Receptacle can supply a maximum of 30 Amps.
8. 120 Volt AC, 20 Amp Duplex NEMA 5-20R
Receptacles: Receptacles can supply a maximum
of 20 Amps.
DATA CENTER
Voltage:
Displays current voltage
output.
METER V-F-T
2
3
15
14
13
Frequency (Hz):
Displays power output
frequency in Hertz.
Push the Mode button to cycle through
the data display modes.
Mode Button
COMPONENTS
4
5
6
12
11
9. 20 Amp AC Circuit Breaker: Circuit breaker limits
the current that can be delivered through the NEMA
5-20R receptacles to 20 Amps.
10. 30 Amp AC Circuit Breaker: Circuit breaker limits
the current that can be delivered through the TT-
30R receptacle to 30 Amps.
11. Ground Terminal: The ground terminal is used to
externally ground the generator.
12. Smart Switch Outlet: Connects the Westinghouse
ST Switch (sold separately) to the control panel.
13. Battery Charging Port: Used to charge the battery
with the included battery charger.
14. Battery Indicator: Indicates that power is ON. Light
will remain illuminated while the unit is ON.
15. CO Sensor indicator lights: The CO Sensor
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
Lifetime Hours:
Displays the lifetime run
hours.
Westinghouse Outdoor Power Equipment, LLC | 9
7 7
8
10
9
Run Time/Maintenance:
Displays current run time.
Resets to zero when shut
down. Maintenance
reminder displayed
when required.
Maintenance Codes:
P25: Change engine oil
P50: Clean air filter,
Change engine oil
P100: Change engine oil,
clean air filter, replace
fuel filter
