Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 8

Do not use the Bosch GCM18V-
12GDC miter saw to cut fiber
cement board. Cutting materials containing crystalline
silica may create exposures to respirable silica dust.
Before each use, review all
warnings located on the miter
saw.
DESIGNATED
DANGER ZONES
Avoid positioning
fingers or arms
Electric Brake
Your saw is equipped with an automatic electric brake
which is designed to stop the blade from spinning in
about five (5) seconds after you release the trigger
switch. It is useful when making certain cuts in wood
where a coasting blade would result in a wide, impre-
cise cut.
When electrical power is lost
due to blown fuse or other
causes, the motor will gradually slow down and the
braking action is initiated ONLY by the release of the
trigger switch.
The electric blade brake of your miter saw has been
designed for highest degree of reliability, but unexpect-
ed circumstances such as contamination on the com-
mutator and brushes or failure of motor's components
can cause the brake not to activate. If this condition
occurs, turn the saw "ON" and "OFF" four to five times
without contacting the workpiece. If the tool operates
8
Additional Safety Rules
DESIGNATED
PINCH POINT AREA
hands, A danger zone – avoid placing hands,
fingers or arms in these areas. never
attempt to move or lift the saw in these
areas.
Electrical Requirements
SAVE THESE INSTRUCTIONS
The operation of any power tool
WARNING
can result in foreign objects
being thrown into the eyes,
which can result in severe eye
damage. Always wear safety
goggles that comply with ANSI
Wear Eye Protection
Z87.1 (shown on pack age)
before commencing power tool operation.
A danger zone – never lift or carry saw
by the main switch handle.
but the brake does not consistently stop the blade in
about five seconds, DO NOT use saw and have it ser-
viced immediately.
The brake action of this saw is
not intended as a safety fea-
ture. Remember to let the saw blade come to a com-
plete stop before raising the blade from the
workpiece. As always, the guard system is your best
protection against unintentional contact with a spin-
ning saw blade. NEVER wedge open or defeat the
closing action of the lower guard.
Do Not Carry the
Saw by this handle.
No lleve la sierra
por este mango.
Ne transportez pas la
scie par sa poignée.
DESIGNATED
NO-CARRY AREA