Corghi Artiglio 50 Manual De Uso página 70

above the mark X fig. 7.
- Check daily that the travel screws of the tool head and each bead breaker unit are
operating correctly. The build-up of dirt in this area may impair operation and cause a
hazard.
- Clean the top plate of the turntable every week: remove any accumulated dirt and clean
with environment-friendly solvents.
- Monthly checks:
• Clean the arms of the tool head and the bead breaker unit, and the relative travel
screws, and lubricate, using environment-friendly solvents only.
• Check the oil level in the air lubricator (fig. 7) and top up if necessary with SAE 20
non-detergent oil to the level Z marked.
• Clean with a dry cloth. Avoid contact with solvents.
• Check the oil flow-rate through the transparent cap K (correct flow-rate: 1 drop of oil every
4 bead breaking cycles). Adjust if necessary by turning the adjuster screw Y fig. 7.
ATTENTION
Keep the working area clean.
Never use compressed air, jets of water or solvent to remove dirt or residues from
the machine.
When cleaning, take care to avoid creating and raising dust as far as possible.
ENVIRONMENTAL INFORMATION
Following disposal procedure shall be exclusively applied to the machines having the
crossed-out bin symbol
This product may contain substances that can be hazardous to the environment or to
human health if it is not disposed of properly.
We therefore provide you with the following information to prevent releases of these
substances and to improve the use of natural resources.
Electrical and electronic equipments should never be disposed of in the usual municipal
waste but must be separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product and in this page, remind you of the
need to dispose of properly the product at the end of its life.
In this way it is possible to prevent that a not specific treatment of the substances con-
tained in these products, or their improper use, or improper use of their parts may be
hazardous to the environment or to human health. Furthermore this helps to recover,
recycle and reuse many of the materials used in these products.
For this purpose the electrical and electronic equipment producers and distributors set
up proper collection and treatment systems for these products.
At the end of life your product contact your distributor to have information on the col-
lection arrangements.
70
on their data plate.
Operator's manual Artiglio 50