Idiomas disponibles
Idiomas disponibles
2
Making Measurements
2 Press
3 Open the circuit path to be tested. Probe the test points and read the display.
Figure 2-30
Reversing the leads will produce a negative reading, but will not damage the
NOTE
multimeter.
– For measuring AC current signals with a DC offset (U1272A only), refer to
CAUTION
– For measuring DC current from a mixed signal in DC measurement mode,
– Press
NOTE
– Press
94
to cycle between DC (
(
or
) current measurements.
DC current display
the
"Measuring AC and DC Signals (U1272A only)"
ensure that the Filter is enabled (Refer to
Filter"
on page 131).
to cycle through the available dual display combinations. See
Dual
E xit
Appendix B, "Dual Display Combinations Using the Dual Key,"
page 159 to learn more.
to enable the frequency test mode for voltage measurements.
See
"Frequency Test Mode"
), AC (
), AC+DC (
"Enabling and disabling the
on page 101 to learn more.
Keysight U1271A/U1272A User's Guide
), or % scale
on page 64.
starting on
