Idiomas disponibles
Idiomas disponibles
4
Multimeter Setup Options
Enabling smooth mode
Smooth is used to smoothen the refresh rate of the readings in order to reduce the
impact of unexpected noise and to help you achieve a stable reading. You can
enable Smooth by holding
options"
turned off when you cycle the multimeter's power. You can permanently enable
Smooth from the Setup mode.
Parameter
SMootH
To enable Smooth:
1 Press
2 Press
Figure 4-18
3 Press
4 Press
5 Press and hold
148
on page 32). This method however is temporary and Smooth will be
Range
(0001.d to 9999.d) or (0001.E to 9999.E)
for more than 1 second to enter the multimeter's setup menu.
Setup
or
SMootH display
or
to set the Smooth refresh rate. To permanently enable
Dual
E xit
Setup
Smooth, change the last digit shown from
to save your changes or press
until the multimeter restarts to return to normal operation.
Setup
while turning on the multimeter
until
is shown on the secondary display.
Keysight U1271A/U1272A User's Guide
("Power-on
Defaul t setting
0009.d (disabled)
(disabled) to
(enabled).
to discard your changes.
