Idiomas disponibles
Idiomas disponibles
Table 1-7
Keypad functions (continued)
Function when pressed for:
Legend
Less than 1 second
Turns the backlight on or off.
Setup
Frequency test mode for current or voltage
measurements is enabled.
– Press
(Hz), pulse width (ms), and duty cycle (%)
measurements.
– In duty cycle and pulse width
measurements, press
between the positive or negative edge
trigger.
– Press
this mode.
Keysight U1271A/U1272A User's Guide
to scroll through the frequency
to switch
Dual
E xit
for more than 1 second to exit
Dual
E xit
More than 1 second
Enters or exits the Setup mode.
– In the Setup mode, press
navigate through the menu pages. Press
or
to cycle through the
available settings, or to edit the existing
values.
– Press
to save the new settings or
values and exit the editing mode, or press
to exit the editing mode without
saving.
– Press
for more than 1 second to exit
Setup
this mode.
Starts and stops the Data Logging.
– If data logging is set as
logging), pressing
1 second will log the present reading into
the memory. The display will return to
normal after a short while (≈ 1 second). To
manually log another reading, press
again for more than 1 second.
– If data logging is set as
data logging), pressing
1 second will enter the automatic data
logging mode, where data is logged at the
interval defined in the multimeter's Setup.
– If data logging is set as
logging), pressing
1 second will enter the event data logging
mode, where data is logged each time a
triggering condition is satisfied.
– Press
for more than 1 second to exit
the automatic or event data logging mode.
Introduction
Learn more
on:
or
to
Dual
E xit
Setup
page 27
and
page 125
(manual data
for more than
(automatic
page 101
for more than
and
page 116
(event data
for more than
1
43
