KitchenAid 5K45 Serie Manual Del Propietário página 7

Ocultar thumbs Ver también para 5K45 Serie:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
USING THE STAND MIXER (CONTINUED)
ATTACHING/REMOVING THE FLAT BEATER*, FLEX EDGE
BEATER*, WIRE WHIP, PASTRY BEATER* OR DOUGH HOOK
1.
To attach accessory: Turn speed control to "O". Unplug Stand Mixer.
2.
Unlock and lift the Motor Head. The lock
in place.
3.
Slip accessory onto Beater Shaft and press upward as far as possible. Then, turn
accessory to the right, hooking accessory over the pin on the shaft.
4.
To remove accessory: Repeat steps 1 and 2. Press accessory upward as far as possible
and turn to the left. Then pull accessory from the Beater Shaft.
BEATER TO BOWL CLEARANCE
Your Stand Mixer is adjusted at the factory so the Flat Beater
Bowl. If, for any reason, the Flat Beater
Bowl, you can correct clearance easily.
1.
Turn Speed Control Lever to "O". Unplug Stand Mixer.
2.
Lift Motor Head. Turn screw slightly counterclockwise (left) to raise Flat Beater
clockwise (right) to lower Flat Beater
surface of Bowl. If you overadjust the screw, the Bowl lock lever may not lock into place.
NOTE: When properly adjusted, the Flat Beater
Bowl. If the Flat Beater
coating may wear off the beater or wires on whip may wear.
CARE AND CLEANING
IMPORTANT: Allow the appliance to cool completely before putting on or taking off parts, and
before cleaning the appliance.
1.
Always be sure to unplug Stand Mixer before cleaning. Wipe Stand Mixer with a soft,
damp cloth. Do not use household/commercial cleaners. Wipe off Beater Shaft frequently,
removing any residue that may accumulate. Do not immerse in water.
**Locking option is available on select models.
WARNING
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in broken
bones, cuts, or bruises.
**
hits the bottom of the Bowl or is too far away from the
**
. Make adjustment with Flat Beater
or the Wire Whip is so close that it strikes the bottom of the Bowl,
**
**
engages automatically to keep the head locked
just clears the bottom of the
**
will not strike on the bottom or side of the
**
or
**
**
, so it just clears
7
loading

Este manual también es adecuado para:

5ksm45 serie5ksm200 serie