Idiomas disponibles
Idiomas disponibles
To select a flash pattern:
1.
Select Mode 1 (red wire), Mode 2 (white wire), or Mode 3 (brown wire).
2. Apply power (+12-24 Vdc) to that wire.
3. To activate FSLink ™ , tap the green wire to + 12-24 Vdc until the desired
pattern is reached. For magnetically mounted lights, you can click the
momentary switch instead of tapping the green wire.
NOTE: When tapping the green wire to change patterns, do not hold
power for longer than one second, or other features of the device will
change.
Selecting Sync or Alt
When setting up devices to be synchronized, they must never be
operated without a ground connection. If a poor ground connection exists,
the unit will operate erratically and the warranty is voided. Routinely
inspect all connections to ensure that they are secure.
The device can synchronize with other Elites. It will either flash with or
alternate the timing of the flashes with other Elites. Select this feature
separately for Mode 1, Mode 2, or Mode 3.
To synchronize your selected flash pattern:
1.
Activate Mode 1, 2, or 3.
2. Connect and hold the green wire to the positive voltage source until
the light pulses twice, and then release it. The light switches from its
initial setting to its opposite. "Flash with" becomes "Alternate," or vice
versa.
3. To synchronize, after setup, connect the green wires together.
For this feature to operate, permanently connect all green wires after all
lights in the system are configured.
Installation, Operation, and Maintenance Instructions
Federal Signal www.fedsig.com
Configuring the HighLighter Elite
19
