Idiomas disponibles
Idiomas disponibles
Safety Message to Installers of Warning Light Equipment
Ensure that all wires and fuses are rated correctly to handle the device
and system amperage requirements.
•
Never attempt to install aftermarket equipment that connects to the
vehicle wiring without reviewing a vehicle wiring diagram available
from the vehicle manufacturer. Ensure that your installation will not
affect vehicle operation or mandated safety functions or circuits.
Always check the vehicle for proper operation after installation.
•
Do not mount a radio antenna within 18 inches of the lighting system.
Placing the antenna too close to the lighting system could cause the
lighting system to malfunction or be damaged by strong radio fields.
Mounting the antenna too close to the lighting system may also cause
the radio noise emitted from the lighting system to interfere with the
reception of the radio transmitter and reduce radio reception.
•
Do not attempt to wash this or any other electrical device while it is
connected to its power source. Exposure to liquid while the product is
connected to the power source may result in an electrical shock and
personal injury and may short circuit and damage the product.
During Installation and Service
•
DO NOT get metal shavings inside the product. Metal shavings in the
product can cause the system to fail. If drilling must be done near the
unit, place an ESD-approved cover over the unit. Inspect the unit after
mounting to ensure that there are no shavings present in or near the
unit.
•
To avoid a battery explosion, always disconnect the negative
battery cable first and reconnect it last. Avoid causing a spark when
connecting near or to the battery. The gases produced by a battery
can cause a battery explosion that could result in vehicle damage and
serious injury.
•
DO NOT connect this system to the vehicle battery until ALL other
electrical connections are made, mounting of all components is
complete, and you have verified that no shorts exist. If the wiring is
shorted to the vehicle body or frame, high current conductors can
cause hazardous sparks, resulting in electrical fires or flying molten
metal.
•
DO NOT install equipment or route wiring (or the plug-in cord) in the
deployment path of an airbag.
Installation, Operation, and Maintenance Instructions
Federal Signal www.fedsig.com
5
