Idiomas disponibles
Idiomas disponibles
Attaching the Light to a Flat Bar
To permanently mount the HighLighter Elite to a flat bar:
1.
Using the bracket as a template, scribe two (2) mounting hole
locations for the installer-supplied 1/4-20 carriage bolts.
DRILLING PRECAUTIONS: When drilling holes, check the area you
are drilling into to ensure that you do not damage vehicle components
while drilling. All drilled holes should be deburred, and all sharp edges
should be smoothed. All wire routings going through drilled holes
should be protected by a grommet or convolute/split loom tubing.
2. Drill two 17/64-inch holes at the scribed marks.
3. Load carriage bolts into the bracket and attach it to the bottom of the
light using the supplied hi-low screws. See Figure 3.
Installation, Operation, and Maintenance Instructions
Federal Signal www.fedsig.com
Permanently Mounting the HighLighter Elite
Figure 3 Bar Mount
#10 Hi-Low Screw
Installer-Supplied
1/4-20 Carriage
Bolts
Light
15
