Idiomas disponibles
Idiomas disponibles
Permanently Mounting the HighLighter Elite
DRILLING PRECAUTIONS: When drilling holes, check the area you
are drilling into to ensure that you do not damage vehicle components
while drilling. All drilled holes should be deburred, and all sharp edges
should be smoothed. All wire routings going through drilled holes
should be protected by a grommet or convolute/split loom tubing.
3. Drill an appropriately sized hole for the installer-supplied #10
hardware.
4. Refer to "Wiring the HighLighter Elite" on page 17 for wire
connections.
5. Plug the supplied connector into the bottom of the light. See Figure 2.
6. Attach the light to the mounting surface using installer-suppled #10
hardware.
14
Figure 2 Connecting the Light
Federal Signal www.fedsig.com
HighLighter
Elite
®
