Idiomas disponibles
Idiomas disponibles
Introduction
Introduction
The HighLighter® Elite is an LED-based warning light with a small footprint
and low current draw. The light is available in one of three mounting
types: Permanent, Suction Cup Magnet, or Magnet. The light has three
modes of operation, 25 selectable light patterns, and an optional low-
power function.
Unpacking the Light Bar
After unpacking the light, inspect it for damage that may have occurred
in transit. If it has been damaged, do not attempt to install or operate it.
File a claim immediately with the carrier, stating the extent of the damage.
Carefully check all envelopes, shipping labels, and tags before removing
or destroying them. Ensure that the parts listed in Table 1 are included in
the package. If you are missing any parts, contact Customer Support at
1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT).
Permanent
Qty Description
1
Mini Light Bar
1
Mounting Bracket
1
Wire Harness
4
#10 Hi-Low Screws
1
Safety Message Card
Preparing for the Light Bar Installation
Determining the Mounting Location and Wire Routing
The following section covers only mounting and wire routing. For
instructions regarding wiring connections, see "Wiring the HighLighter
Elite" on page 17.
To prepare for the installation:
•
Ensure that the battery voltage is the same as the voltage rating of the
light bar.
•
Verify that the light bar and mounting hardware fit the vehicle.
•
Determine where to mount the light bar on the vehicle.
10
Table 1 Kit Contents
Suction Cup Magnet
Qty Description
1
Mini Light Bar
1
Safety Message Card
Federal Signal www.fedsig.com
Magnet
Qty
Description
1
Mini Light Bar
4
Protective Stickers
1
Safety Message Card
HighLighter
Elite
®
