Idiomas disponibles
Idiomas disponibles
Configuring the HighLighter Elite
4. Connect the end of the fuse holder to the positive (+) terminal of the
voltage source.
5. Connect the black (–) wire from the Elite to a known good vehicle
ground as close to the light as practical. The black wire is ground and
must be connected to a suitable chassis ground if it cannot be taken
directly to the negative terminal of the battery.
6. The green wire has two functions: It is the runner wire that
synchronizes FSLink ™ -Equipped products, and it serves as the
function/pattern programming wire.
7.
The red wire powers the device in Mode 1 when connected to a
fused, positive voltage. Mode 1 is set to single/double/quad (pattern
no. 1) by default.
8. The white wire powers the device in Mode 2 when connected to
a fused, positive voltage. If Mode 1 is active, powering Mode 2 will
override Mode 1. Mode 2 is set to steady (pattern no. 10) by default.
9. The brown wire powers the device in Mode 3 when connected to a
fused, positive voltage. If Modes 1 or 2 are active, powering Mode 3
will override Modes 1 and 2. Mode 3 is set to cruise (pattern no. 7) by
default.
Configuring the HighLighter Elite
If the Elite's operating functions are to be changed from the default,
perform the following steps.
Selecting a Flash Pattern
LIGHT HAZARD: This product contains a high-intensity LED device. To
prevent permanent eye damage, DO NOT stare into the light beam at
close range.
Selecting a flash pattern from the device's internal library of flash patterns
is optional. It should be done during installation. For available flash
patterns, see Table 3 on page 22.
18
Federal Signal www.fedsig.com
HighLighter
Elite
®
